Hi Elmar,
PLoP is perfect for me, I use it for booting from my USB HDD without changing the boot order.
However, I would like to boot the L1 (on ext partition 2) of my USB HDD by default, but I use the boot.ini solution. Is it possible to use plpcfgbt.exe to configure the default boot on the L1, meaning can I change the profile for HDB partition 2 to L1 before booting, like I currently need to do manually before every boot?
Thanks!
hi,
i have to add this to plpcfgbt
best regards
elmar
please try the new plpcfgbt
http://www.plop.at/en/bootmanagerdl.html
there are new parameters.
in your case for the usb harddisk detected by the bios, extended partiton, and a new label: plpcfgbt prf=6 btlog=1 prfname="bios usb-hd l1" plpbt.bin
best regards
elmar
Wow, I knew you were fast to respond, but I'm surprised you already have an update for me.
I also saw you made a change to the params, I had to specify dprf=6 as well, but it works like a charm.
However, the prtname param doesn't seem to do anything, unless it's a way to identify the btdrv? The menu doesn't display the string anywhere.
Also, I need to enter a dprf with a 5 (zero-based?) instead of a 6...
Well, thanks a lot for your support and quick response!
Best regards!
i made a typo, ptrname was wrong, correct is prfname.
i have to change dprf that its not zero based
please download and try plpcfgbt again
regards
elmar
Good, not zero-based anymore. I do not see the prfname anywhere, though, but I don't need this much anyway...
You're releasing almost faster than I can test them!!! Thanks again!