I have flash (plpbt-5.0.11) plop pci rom to pci lancard 8139 bootrom and it work fine in AWARD bios mainboard.
But when I insert the lancard to another mainboard with AMI bios,
it is no work. the boot Main menu cannot start.(cmos have set BOOT from LAN)
I have try two different AMI mainboard, it is also no work.
I have also install the plpbt-5.0.11 to Harddisk, it work fine.
Have anybody with same problem?
did you see anything on the screen? does the boot process hang?
regards
elmar
I can see Press D to disable....., and 2 second count down.
And then it clean screen very fast, and go to boot HD.
regards
Henry
did you set the boot manager in the bios boot sequence before the hard disk?
Yes, The BIOS setting boot from LAN is 1st select. HD is 2nd select.
did you use the parameter -forceINT and -INT18 with plpbtrom program?
I have no change int19h setting in cfg.The hotkey is off.
The parameter -forceINT and -INT18 is bios setting or cfg plpbtrom ?
its from plpbtrom.
try -forceINT, but not -INT18
make boot rom use :
plpbtrom -forceINT -vendorid 0x10ec -deviceid 0x8139 plpbtrom.bin plpbt.rom
Both of AMI /AWD bios,Boot Main menu start.
Thanks
hi henry136,
please test this version without -forceINT and tell me if it works or not
http://download.plop.at/tmp/plpbtrom-0.4-test3.zip
best regards
elmar
Test report:
1.TEST3 version without -forceINT
AMI BIOS (M741LMRT)=NO WORK
AMI BOS (MSKM400A-M)= NO WORK
AWARD BIOS ( JETWAY 830CF)= WORK
2. with -forceINT
AMI BIOS (M741LMRT)=WORK
AMI BOS (MSKM400A-M)= NO WORK
AWARD BIOS ( JETWAY 830CF)= WORK
NOTE : WORK = boot menu come out
NO WORK = CAN SEE Press D to disable..... but no boot menu.