Started by Ilya, December 16, 2010, 07:49:41 AM
Quote from: Ilya on December 16, 2010, 09:17:18 AMWill that work?
Quote from: Ilya on December 16, 2010, 09:27:07 AMso to load the ROM on the cardbus, I use the cmdline:plpbtrom -vendorid 0x1385 -deviceid 0x511A plpbtrom.bin plpbt.romis that right?
Quote from: Ilya on December 16, 2010, 10:50:25 AMToshiba's proprietary BIOS and NETGEAR's ROM are not yet known how to modify then?
Quoteflashrom is a utility for identifying, reading, writing, verifying and erasing flash chips. It is designed to flash BIOS/EFI/coreboot/firmware/optionROM images on mainboards, network/graphics/storage controller cards, and various programmer devices. * Supports more than 261 flash chips, 152 chipsets, 259 mainboards, 43 PCI devices, 5 USB devices and various parallel/serial port-based programmers. * Supports parallel, LPC, FWH and SPI flash interfaces and various chip packages (DIP32, PLCC32, DIP8, SO8/SOIC8, TSOP32, TSOP40, TSOP48, and more) * No physical access needed, root access is sufficient. * No bootable floppy disk, bootable CD-ROM or other media needed. * No keyboard or monitor needed. Simply reflash remotely via SSH. * No instant reboot needed. Reflash your chip in a running system, verify it, be happy. The new firmware will be present next time you boot. * Crossflashing and hotflashing is possible as long as the flash chips are electrically and logically compatible (same protocol). Great for recovery. * Scriptability. Reflash a whole pool of identical machines at the same time from the command line. It is recommended to check flashrom output and error codes. * Speed. flashrom is often much faster than most vendor flash tools. * Portability. Supports DOS, Linux, FreeBSD, NetBSD, OpenBSD, DragonFly BSD, Solaris, Mac OS X, and other Unix-like OSes. Partial Windows support is available (full support as patch).