Boot PLOP from Lan 8139 bootrom problem.(ok!)

[henry136]

I have flash (plpbt-5.0.11) plop pci rom to pci lancard 8139 bootrom and it work fine in AWARD bios mainboard.
But when I insert the lancard to another mainboard with AMI bios,
it is no work. the boot Main menu cannot start.(cmos have set BOOT from LAN)
I have try two different AMI mainboard, it is also no work.

I have also install the plpbt-5.0.11 to Harddisk, it work fine.

Have anybody with same problem?

[Elmar]

did you see anything on the screen? does the boot process hang?

regards
elmar

[henry136]

I can see Press D to disable....., and 2 second count down.
And then it clean screen very fast, and go to boot HD.

regards
Henry

[Elmar]

did you set the boot manager in the bios boot sequence before the hard disk?

[henry136]

Yes, The BIOS setting boot from LAN is 1st select. HD is 2nd select.

[Elmar]

did you use the parameter -forceINT and -INT18 with plpbtrom program?

[henry136]

I have no change int19h setting in cfg.The hotkey is off.
The parameter -forceINT and -INT18 is bios setting or cfg plpbtrom ?

[Elmar]

its from plpbtrom.
try -forceINT, but not -INT18

[henry136]

make boot rom use :
plpbtrom -forceINT -vendorid 0x10ec -deviceid 0x8139 plpbtrom.bin plpbt.rom

Both of AMI /AWD bios,Boot Main menu start.
Thanks

[Elmar]

hi henry136,
please test this version without -forceINT and tell me if it works or not
http://download.plop.at/tmp/plpbtrom-0.4-test3.zip

best regards
elmar

[henry136]

Test report:
1.TEST3 version without -forceINT
   AMI BIOS (M741LMRT)=NO WORK
   AMI BOS (MSKM400A-M)= NO WORK
   AWARD BIOS ( JETWAY 830CF)= WORK
2. with -forceINT
   AMI BIOS (M741LMRT)=WORK
   AMI BOS (MSKM400A-M)= NO WORK
   AWARD BIOS ( JETWAY 830CF)= WORK

NOTE : WORK = boot menu come out
           NO WORK = CAN SEE Press D to disable..... but no boot menu.